What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 22.06.2025 04:05

I post the exact comment here.
What is lightning?
Edit 2024–10.
Veteran investor makes surprising Fed rate call after jobs report - TheStreet
These devices are installed between the “hot” and “neutral” and protective ground.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
But it can get overloaded, and no longer works.
Record-breaking cosmic structure discovered in colossal galaxy cluster - Phys.org
so, what happens?
There are three different concepts here that are getting confused.
Barnstars:
A fuse is a non-resetable over current circuit protector.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Would you date/marry a guy younger than you? If no, why not?
First Sentence:
Can the fuse protect the electronic devices from lightning instead of a surge protector.
One
One is “what exactly is in a ‘surge protector’ ? ”
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
He then asserts :
What are the latest trends in artificial intelligence for 2025?
This one hit behind the barn.
He then describes Rainy Season and Lightning.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
a photo is worth a thousand words.
The bolt then partially travels down the line to your home.
but this device (an Inductor) … impedes the rapid changes in the current.
This device then solves the entire problem.
But… the neutral is now “floating” because of the 1 ohm resistance.
Scientists Stunned by Evidence of Ancient Birds Nested in the Arctic - The Daily Galaxy
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
So, the voltage could go up to 500 volts, and the fuse will not open up.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
At least they know the answer if they wanted it.
2024–10–16 [ OO OLAOYE OYEBODE ]
what exactly is a ‘surge’ protector?
Here is a simplified AC power diagram.
What are some common examples of human hypocrisy?
Now when you have a certain ac resistance, then a current flows in a loop.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Shedeur Sanders Near-Perfect During Browns Drills on Wednesday - Sports Illustrated
He then describes the function of a fuse.
This is where the MOV conducts again, and dissipated the energy.
A circuit breaker is similar, but is resettable.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
There are two important concepts here.
Dementia: Switching to MIND diet even later in life can lower risk - Medical News Today
The MOV will conduct when the voltage exceeds 50% of line voltage.
It seems Mohan does not understand the difference between a comment and an Answer.
2024–10–14 [Omar Gharbi Omar Gharbi ]
eight
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
the problem then depends on "how fast does the fuse operate?".
At one ohm, the resistor has a maximum of 1 watt power.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
but I think this circuit , shows a few more pieces.
For this case there are devices called Metal oxide varistors (MOV).
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
[old diagram got deleted by accident]
In schematic diagrams this is the symbol for a fuse:
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
nine
Upvotes:
This is 'the assistant's answer'
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
[image of Common-mode choke]
The other is “what does a “fuse” do?”
An AC voltage/ current source, and an ac inductive load.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
It also is a device that limits the change in current flow.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
What does a fuse do?
Because the load is inductive, the current lags the voltage.(by a bit).
These are simplified answers to the original question, and does not change anything I wrote above.
2024–10–10[John johnson John Johnson ]
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
The third is lightning and “how it gets conducted into a home.”
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
(Dc diagram shown, AC is similar).
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.